Calibrator Calibrator/Status and Test Information
______________________________________________________________________________
MillipaK PUMP Controller Manual Page 14 07/11/05
Status and Test Information
Menus 13 to 19 are primarily used for providing information about the system. Every parameter
which the system measures in located in one of these menus. A brief description of the purpose of
each menu is listed below.
Menu Name Purpose
13 System Status
If there is a fault active in the system, this menu provides
information about what the fault is. Refer to the Diagnostics
section for more information.
14 - Reserved for future use.
15 System Voltages
Used to display Battery and Capacitor Voltage measurements.
The Battery Voltage measurement shows the voltage measured
at the Keyswitch pin (pin 1 on connector B). The Capacitor
Voltage measurement shows the voltage measured at the B+
terminal.
16 Motor Voltages Used to show the voltage measured at the Point A terminal.
17 Motor Current Used to show the PUMP motor current Measurement.
18
Heatsink
Temperature
Used to access the Heatsink Temperature measurement and the
Maximum Heatsink Temperature log. Refer to the Temperature
Monitoring section.
19 Test Menu
Used to access items which allow for testing of all the Analogue
and Digital inputs available on connector B. Also displays unit
information such as the Software Version, Controller Serial
Number and the Personality Checksum. Refer to the appropriate
sections for more information on each of these items.
To Next Page
Loading...
Need help?
General
