SEW-Eurodrive MOVIMOT flexible MMF1 C/DBC Series - Service; Evaluating fault messages

8
Service
Evaluating fault messages
Operating Instructions – MOVIMOT
®
flexible
190
8 Service
8.1 Evaluating fault messages
8.1.1 MOVISUITE
®
The following section shows a sample evaluation of a fault message in MOVISUITE
®
:
1. Open the parameter tree in MOVISUITE
®
.
2. In the parameter tree [6], select the "Status" node.
ð The current fault messages can be found in the "Fault status" [5] group.
ð Additional information on the causes for the "Not ready” status can be found
in the "Device status" [4] group.
ð Information on the history of the fault messages can be found in the "Fault
memory" [7] node.
27021619739281291
[1] Fault status of the main component
[2] Fault status of the subcomponent
[3] Display of the status bits
29129451/EN – 12/2019