29
Product Version 1.0 | Revision D | Released 2022-06-20
INDIVIDUAL FIXTURE SETTINGS
If the fixture is installed hanging upside down, it might be useful to flip the display so that it is easier to read.
To flip the display, press ENTER and select SETTINGS → FLIP DISPLAY, or press the up and down buttons on the control
panel at the same time.
By default, the OLED display turns off after a short period when the control panel is not in use. The display can also be
set to dim down. Pressing any key will always turn on the display or restore it to normal brightness.
To configure the display settings, press ENTER → SETTINGS → DISPLAY SAVER.
NOTE: To avoid the risk of display deterioration caused by long term use, it is recommended to select the setting →
DISPLAY OFF.
Setting the fan mode
For operating environments where low-noise is a requirement or where the fixture will be operating in high tempera-
tures, it is possible to adjust the default fan speed by going to SETTINGS → FAN MODE in the menu.
To Next Page
Loading...
