Why can't I specify a destination on my Sharp MX-M950?
Some functions may have been disabled in the system settings (administrator). Check with your administrator. When user authentication is enabled, the functions that you can use and page counts may be restricted in your user settings. Check with your administrator.
How to fix Sharp All in One Printer printing on the wrong side of the paper?
If printing takes place on the wrong side of the paper, load the paper with the front side facing down in trays 1 to 4. For the bypass tray and trays 5, 6, and 7, load the paper with the front side facing up.
Why does auto selection of the color mode not take place correctly on my Sharp MX-M950 All in One Printer?
When the color mode is set to "Auto", the machine detects whether the original is black and white or color when the [START] key is pressed; however, automatic detection may not give the correct result. In this event, specify the color mode manually.
Why punching does not take place on Sharp All in One Printer?
If punching does not take place, dispose of punch scraps if a message appears instructing you to check the punch module. Ensure paper of different sizes is not mixed together. Verify that the paper size can be punched (see the specifications in the Safety Guide) and that the tray selected in the printer driver is set to a paper type that can be punched. Also, some functions may have been disabled in the system settings by the administrator, so check with your administrator.
Why stapling does not take place on Sharp All in One Printer?
If stapling does not take place, remove jammed staples or replace the staple cartridge, including the staple case, if a message appears instructing you to do so. Ensure paper of different widths is not mixed; use the [Same Width] setting for mixed size stapling. Check that the number of sheets does not exceed the maximum stapling capacity (refer to the Safety Guide). Verify that the paper size can be stapled (refer to the Safety Guide) and that the paper type setting of the tray selected in the printer driver is set to a paper type that can be stapled. Note that saddle stitch is not possible on heavy paper. Some functions may have been disabled in the system settings by the administrator, so check with your administrator.
How to fix part of the image being cut off on Sharp All in One Printer?
If part of the image is cut off, ensure the correct paper size is set, especially if using a special size. If using the document glass, place the original in the far left corner.
How to fix poor quality of scanned image on Sharp MX-M950 All in One Printer?
If the original is printed matter such as a book or magazine, vertical patterns (moiré) may occur. Touch the [Exposure] key in the base screen to open the exposure setting screen; the [Moiré Reduction] checkbox appears in this screen. Also, if you are scanning a color or grayscale original, ensure that the color mode is not set to "Mono2". Setting the color mode to "Mono2" replaces the colors in the original with either black or white, which is suitable for text-only originals; however, originals with illustrations should be scanned with the color mode set to [Grayscale], [Full Color], or [Auto] - [Grayscale].
Why is the scanned image clipped on my Sharp All in One Printer?
The original scan size setting might be smaller than the actual original size. Set the scan size to the actual original size. If you have intentionally set a smaller size than the actual original size, note carefully the placement position of the selected scan size when placing the original.
Why does my Sharp MX-M950 All in One Printer not print after reception?
If a message appears on the display indicating that you need to add toner or paper, printing will not be possible. Restore printing capability by following the instructions provided in the message.
What to do if my Sharp MX-M950 transmitted fax prints out blank at the receiving side?
Ensure the original is placed correctly (face up or face down, as required by the sending method) and send the fax again.
General| Brand | Sharp |
|---|---|
| Model | MX-M950 |
| Category | All in One Printer |
| Language | English |
To Next Page
