Sharp XE-A307 - Zero Skip; Print Select

103
■
Zero skip
You can program whether or not to skip “0” in each report.
Procedure
Program each item as follows:
• DEPARTMENT (Use the selective entry)
SKIP: Skips those data that are “0” in the department
report.
NOT SKIP: Does not skip those data that are “0” in the
department report.
• TRANSACTION (Use the selective entry)
SKIP: Skips those data that are “0” in the transaction
report.
NOT SKIP: Does not skip those data that are “0” in the
transaction report.
• PLU (Use the selective entry)
SKIP: Skips those data that are “0” in the PLU/EAN report.
NOT SKIP: Does not skip those data that are “0” in the PLU/EAN report.
• CLERK (Use the selective entry)
SKIP: Skips those data that are “0” in the clerk report.
NOT SKIP: Does not skip those data that are “0” in the clerk report.
• HOURLY (Use the selective entry)
SKIP: Skips those data that are “0” in the hourly report.
NOT SKIP: Does not skip those data that are “0” in the hourly report.
• DAILY NET (Use the selective entry)
SKIP: Skips those data that are “0” in the daily net report.
NOT SKIP: Does not skip those data that are “0” in the daily net report.
■
Print select
You can program whether or not to print the item on the report.
Procedure
Program each item as follows:
The screen continues.
• SEPARATOR LINE (Use the selective entry)
YES: Print the separate line on the report.
NO: Not to print the separate line on the report.
• Z COUNTER (Use the selective entry)
YES: Print the Z counter on the Z report.
NO: Not to print the Z counter on the Z report.
• GT1 ON Z (Use the selective entry)
YES: Print GT1 on the Z report.
NO: Not to print GT1 on the Z report.
• GT2 ON Z (Use the selective entry)
YES: Print GT2 on the Z report.
NO: Not to print GT2 on the Z report.
• GT3 ON Z (Use the selective entry)
YES: Print GT3 on the Z report.
NO: Not to print GT3 on the Z report.
• TR GT ON Z (Use the selective entry)
YES: Print the training GT on the Z report.
NO: Not to print the training GT on the Z report.