Sharp XE-A307 - Overlapped Clerk Entry

38
Overlapped Clerk Entry
This function allows to switch from one clerk to another clerk and to interrupt the rst clerk’s entry. So the
second clerk can do his or her entry in this mode. Interrupt handling is possible only in the overlapped clerk
entry.
For actual use of this function, please change the programming of overlapped clerk function ("OVERLAPPED
CLERK : YES/NO"). Please refer to "Basic System" in "Optional Feature Selection" programming.
NOTE
• The overlapped clerk entry is not effective while the tendering sale is going on.
• If any clerk is still making an entry (or has not nalized the transaction yet), the register does not
run in any mode other than REG and MGR, and no X/Z reports can be printed. The message
“CLERK REMAINED” and the related clerk are displayed.
• The overlapped clerk can be entered up to 5 clerks at the same timing, if the 6th clerk is
entered, it cause the error.
Example
Clerk 1: Entry started
Clerk 2: Clerk change (1 to 2), interrupt initiated
Clerk 2: Transaction nished
Clerk 1: Clerk change (2 to 1), entry restarted
Key operation Display
1
L
1
3
2
L
3
@
2
A
1
L
1
3
A
[Clerk 1 is assigned.]
[Clerk 2 is assigned.]
[Clerk 1 is assigned.]