Sharp XE-A307 - Installing and Replacing Paper Rolls

135
Replacing the Paper Roll
■
Recording paper specications
Be sure to use paper rolls specied by SHARP.
The use of any other paper rolls than specied could cause paper jamming, resulting in register malfunction.
Paper specication
Paper width: 57.5 ± 0.5 mm
Max. outside diameter: 80 mm
Quality: High quality (0.06 to 0.08 mm thickness)
• Be sure to set a paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful then to set the roll and cut the paper end correctly.
■
Installing Paper Rolls
The register can print redeipts and journals. For the printer, you must install the paper rolls (receipt and
journal paper rolls) provided with the register.
1.
Remove the printer cover.
2.
Lift up the print roller arm of the receipt side.
3.
Set a paper roll in the paper roll cradle of the receipt side as per
the diagram.
4.
Feed the end of the paper along with the paper positioning guides
as per the diagram.
5.
While holding down the paper, slowly close the print roller arm
of the receipt side, and push down the arm until you hear a click
locking the arm.
NOTE
If the print roller arm is not securely locked, printing is
not done right. If this problem occurs, open the arm,
and close the arm instructed above.
To the printer
Incorrect
To the printer
Correct
Correct Incorrect
(How to set the paper roll) (How to cut the paper end)
Print roller arm
Paper positioning
guides