136
6.
Cut off the excess paper.
7.
Lift up the print roller arm of the journal side.
8.
Set a paper roll in the paper roll cradle of the journal side as per
the diagram.
9.
While holding down the paper, slowly close the print roller arm
of the journal side, and push down the arm until you hear a click
locking the arm.
10.
Remove the paper holding plate from the spool.
Insert the end of the paper into the slit in the spool. (Press the
journal paper feed key to feed more paper if required.)
Wind the paper two or three turns around the spool shaft.
Print roller arm
Paper positioning
guides
Spool
Paper holding
plate
To Next Page
Loading...
