Sharp XE-A307 - Online; Scanner

110
■
Online
Procedure
Program each item as follows:
The screen continues.
• TERMINAL No. (Use the numeric entry)
Terminal number (6 digits: 0 to 999999).
• CI SIGNAL (Use the selective entry)
Sensing of the CI signal
NON: Disables sensing of the CI signal
SENSING: Enables sensing of the CI signal
• LINE FORM (Use the selective entry)
Programming of the modem control
FULL: Full duplex system
HALF: Half duplex system
• BAUD RATE (Use the selective entry)
Transmission data rate
38400 bps 19200 bps
9600 bps 4800 bps
• START CODE (Use the numeric entry)
Start code (3 digits: 0 to 127)
• END CODE (Use the numeric entry)
End code (3 digits: 0 to 127)
• TIME OUT (Use the numeric entry)
Programming of the time-out time (3 digits: 1 to 255 sec.)
■
Scanner
Procedure
Program each item as follows:
• TYPE (Use the selective entry)
Selection of the scanner type
RS-CS CONTROL
RS-CD CONTROL
• BAUD RATE (Use the selective entry)
Transmission data rate
19200 bps 9600 bps 4800 bps
• DATA BIT (Use the selective entry)
Selection of the data bit
7 bits 8 bits
• PARITY (Use the selective entry)
Selection of the parity bit
NON ODD EVEN
• STOP BIT (Use the selective entry)
Selection of the stop bit
1 bit 2 bits
• ITF14 (Use the selective entry)
W LENGTH: With length
W/O LENGTH: Without length