Sharp XE-A307 - Cleaning the Printer (Printer Head;Sensor;Roller)

139
Cleaning the Printer (Printer Head/Sensor/Roller)
When the printed text is getting dark or faint, paper dust may be stuck to the printer head, sensor and/or
roller. Clean them as follows:
CAUTION: Never touch the printer head with a tool or anything hard as it may damage the head.
The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
1.
Select the OFF mode.
2.
Remove the printer cover.
3.
Lift up the print roller arm.
4.
Remove the paper roll referring to the “Removing the
paper roll” section.
5.
Clean the printer head with a cotton swab or soft rag
moistened with ethyl alcohol or isopropyl alcohol.
Clean the roller and the sensor in the same manner.
6.
Reset the paper roll correctly by following the steps in
“Installing the paper roll.”
Printer head
Sensor
Roller
Print roller arm