9(107)
1. General Description
Read this manual carefully before operation to prevent damage of the
machine or personal injuries.
STM-W series water heater are used to heat up the mould and maintain
temperature, although they can be used in other similar applications. High
temperature water from the mould is returned to the cooling tank and cooled by
either indirect cooling (For high temperature models) or direct cooling (for
standard models). It is then pressurised by the high - pressure pump, sent to the
heating tank and finally to the mould with a constant temperature. The
HANYOUNG temperature controller can maintain an accuracy of ±1℃.
Model: STM-607W
To Next Page
Loading...
Need help?
General
