EasyManuals Logo

Shini STM-W Series User Manual

Shini STM-W Series
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #93 background imageLoading...
Page #93 background image
93(107)
Picture 4-11: Equipment Setting
13) Set mold temperature (if temp. has been set, this step can be ignored). Press
SV key and control target value column will be flashing, press / key to
move cursor then press / key to change values. Finally press SET key to
confirm them. Maximum setting temperature of STM is 120.
14) After setting the target value, press RUN/RESET key to begin temperature

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shini STM-W Series and is the answer not in the manual?

Shini STM-W Series Specifications

General IconGeneral
BrandShini
ModelSTM-W Series
CategoryWater Heater
LanguageEnglish

Related product manuals