Shure Microflex Advance MXA910 - Page 49

Where xx is channel number. Where
{yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy} is 31 char
channel name.Value is padded with spaces as
needed to ensure that 31 char are always reported.
MXA910 Response:
< REP xx NA_CHAN_NAME {yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy} >
Get Control Network MAC Address
Command String:
< GET CONTROL_MAC_ADDR >
Where yy:yy:yy:yy:yy:yy is a 17 char literal string
formatted as 6 octets, each separated by a colon.
Example: 00:0E:DD:FF:F1:63
MXA910 Response:
< REP CONTROL_ MAC_ADDR yy:yy:yy:yy:yy:yy >
Get Device Mute LED State
Command String:
< GET DEV_MUTE_STATUS_LED_STATE >
ON = MUTED OFF = UNMUTED
MXA910 Response:
< REP DEV_MUTE_STATUS_LED_STATE ON >
< REP DEV_MUTE_STATUS_LED_STATE OFF >
Restore Default Settings (firmware > v2.0)
Request the device to set itself to default settings.
Command String:
< SET DEFAULT_SETTINGS >
where xx = 00 if restore is successful
MXA910 Response:
< REP PRESET xx >
Get Active Mic Channels
Command String:
< GET NUM_ACTIVE_MICS >
where x is number of active channels that takes on
values: MXA910: channels 1-8
MXA910 Response:
< REP NUM_ACTIVE_MICS x >
Get PEQ Filter Enable (firmware > v2.0)
Where xx is the PEQ block 01-04. Where yy is the
PEQ filter 01-04 within the block. 00 can be used
for all blocks or all filters.
Command String:
< GET xx PEQ yy >
MXA910 Response:
< REP xx PEQ yy ON >
< REP xx PEQ yy OFF >
Set PEQ Filter Enable (firmware > v2.0)
Send one of these commands to the MXA910.
Command String:
< SET xx PEQ yy ON >
< SET xx PEQ yy OFF >
Where xx is the PEQ block 01-04. Where yy is the
PEQ filter 01-04 within the block. 00 can be used
for all blocks or all filters.
MXA910 Response:
< REP xx PEQ yy ON >
< REP xx PEQ yy OFF >
Get Automix Channel Solo Enable
where x is channel number: 0 is not valid MXA910:
channels 1-8
Command String:
< GET x CHAN_AUTOMIX_SOLO_EN >
where x is channel number: 0 is not valid MXA910:
channels 1-8; where sts indicates channel x's SOLO
state: ENABLE DISABLE
MXA910 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
Set Automix Channel Solo Enable
Shure IncorporatedMXA910 Ceiling Array Microphone
49/572017/10/18