SolutionProblem
If talker is in a corner or very close
to a wall, acoustic reflections may
interfere with localization accuracy.
Try automatic positioning again, and
if the issue persists, manual
positioning may be necessary.
Auto-positioning identifies incorrect
location
SolutionProblem
•The network switch must supply
Power over Ethernet. Otherwise,
a PoE injector must be used
•Check network cables and con-
nections
Microphone does not power on
Important Product Information
The equipment is intended to be used in professional audio applications.
Note: This device is not intended to be connected directly to a public internet
network.
EMC conformance to Environment E2: Commercial and Light Industrial.
Testing is based on the use of supplied and recommended cable types. The
use of other than shielded (screened) cable types may degrade EMC perfor-
mance.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate this equipment.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
Authorized under the verification provision of FCC Part 15B.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.
Information to the user
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: +49-7262-92 49 0
Fax: +49-7262-92 49 11 4
Email: info@shure.de
This product meets the Essential Requirements of all relevant European di-
rectives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from Shure Incorporated
or any of its European representatives. For contact information please visit
www.shure.com
Specifications
All specifications measured from narrow beam width. Values for all widths are within ± 3 dB of these specifications unless otherwise noted.
Beam Width
35 degreesNarrow
Adjustable 45 degreesMedium
55 degreesWide
Connector Type
RJ45
Power Requirements
Power over Ethernet (PoE), Class 0
Power Consumption
9W, maximum
Weight
4.26 kg (9.4 lbs)
Shure IncorporatedMXA910 Ceiling Array Microphone
51/572017/10/18
To Next Page
Loading...
