where x is channel number: 0 is not valid MXA910:
channels 1-8; where sts determines the requested
state of SOLO mode: ENABLE DISABLE
Command String:
< SET x CHAN_AUTOMIX_SOLO_EN ENABLE >
< SET x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not valid MXA910:
channels 1-8; where sts indicates channel x's SOLO
state: ENABLE DISABLE
MXA910 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
Get Encryption Status (firmware > v2.0)
Get device level encryption status;
Command String:
< GET ENCRYPTION >
Send one of these commands to the MXA910.
MXA910 Response:
< REP ENCRYPTION ON >
< REP ENCRYPTION OFF >
Get Flash
Command String:
< GET FLASH >
The MXA910 will respond with one of these
commands.
MXA910 Response:
< REP FLASH ON >
< REP FLASH OFF >
Set Flash
Send one of these commands to the MXA910.
Command String:
< SET FLASH ON >
< SET FLASH OFF >
The MXA910 will respond with one of these
commands.
MXA910 Response:
< REP FLASH ON >
< REP FLASH OFF >
Troubleshooting
Troubleshooting
Troubleshooting
SolutionProblem
Problem is browser-related. Turn off
hardware acceleration option in
Chrome.
Software lags in Google Chrome
browser
•Check that lobes have been
aimed to the desired area.
•Use equalizer to adjust frequency
response on a single channel or
on the automix channel. See the
equalizer applications for the ap-
propriate use.
Sound quality is muffled or hollow
SolutionProblem
•Ensure the devices are powered
•Ensure PC and equipment are on
the same network and set to the
same subnet
•Turn off other network interfaces
not used to connect to the device
(including WiFi)
•Check that DHCP server is func-
tioning (if applicable)
•Reset the device if necessary
Microphone does not show up in
device discovery
•Check cables
•Verify that channels are not mut-
ed
•Make sure channels are aimed in
the right direction
•Check that fader levels are not
set too low
•If using automixing, check the
settings to ensure channels are
gating on/off properly
Audio is not present or is
quiet/distorted
Check if brightness is disabled or if
any Light Bar settings are turned off.
No lights
Shure IncorporatedMXA910 Ceiling Array Microphone
2017/10/1850/57
To Next Page
Loading...
