SICK DL100 Pro EtherNet/IP - Page 31

■
To ensure the highest possible EMC resistance, the alignment bracket must be
fastened so that it has a low-resistance electrical connection to the system.
■
During installation, pay attention to the different cable groups. The cables are
grouped into the following four groups according to their sensitivity to interference
or radiated emissions:
°
Group 1: cables very sensitive to interference, such as analog measuring
cables
°
Group 2: cables sensitive to interference, such as device cables, communica‐
tion signals, bus signals
°
Group 3: cables that are a source of interference, such as control cables for
inductive loads and motor brakes
°
Group 4: cables that are a powerful source of interference, such as out‐
put cables from frequency inverters, welding system power supplies, power
cables
b
Cables in groups 1, 2 and 3, 4 must be crossed at right angles (see
figure 16).
b
Route the cables in groups 1, 2 and 3, 4 in different cable channels or
use metallic separators (see figure 17 and see figure 18). This applies partic‐
ularly if cables of devices with a high level of radiated emission, such as
frequency converters, are laid parallel to device cables.
1
2
4
3
1
2
4
3
90
90
Figure 16: Cross cables at right angles
1
2
3
4
Figure 17: Ideal laying – Place cables in different cable channels
ELECTRICAL INSTALLATION
6
8016994/19HB/2022-03-15 | SICK O P E R A T I N G I N S T R U C T I O N S | DL100 Pro EtherNet/IP
31
Subject to change without notice