SICK microScan3 EtherNet/IP - Reports; Service

7.18 Reports
You can show a device’s data with a report. You have the option of saving and archiving
t
hese data as a PDF.
Safety Designer creates a report as soon as you click on Report in the navigation. If after
configuration changes you click on Update, you will receive an updated report.
National and international standards promote or recommend specific data and the per‐
son responsible for it. The required data is included in the report.
1. Print the report.
2. Write down the responsible person on the report.
3. Archive the report.
Figure 74: Report
1
Contents of the report
2
Composition of the report
You compose the contents of a report individually:
1.
Select the contents of the report under Settings for reports.
✓
Safety Designer creates a report with the selected contents.
7.19 Service
This section describes service options you have with Safety Designer on the safety laser
sc
anner.
7 C
ONFIGURATION
120
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/15ZT/2019-11-14 | SICK
Subject to change without notice