Figure 37: Recommended fitting height
Figure 38: Recommended fitting height for inverted mounting
4.4 Integrating the equipment into the electrical control
This chapter contains important information about integration in the electrical control.
Inf
ormation about the individual steps for electrical installation of the device: see "Elec‐
trical installation", page 77.
Information about pin assignment: see "Pin assignment", page 78.
Requirements for use
The protective device delivers safety-related shut-off signals via the network. Reliable
evaluation and switch-off of the machine must be realized in the machine controller.
4 PROJECT PLANNING
52
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/15ZT/2019-11-14 | SICK
Subject to change without notice
To Next Page
Loading...
