SICK microScan3 EtherNet/IP - Identification

7.6 Identification
Overview
Figure 59: Identification
1
Parameters for the project and the device
2
Safety network number (SNN)
In the Ident
ification dialog box, you can assign names and information to uniquely iden‐
tify the application, project, and devices.
Device name
If a number of safety laser scanners are used in an application or in a project, a unique
device name helps to tell the individual devices apart.
b
Give each device a unique device name.
Project name
The project name is used to identify an entire project. The same project name should
be chosen for all devices in the project.
b
Enter a project name.
Application name
The application name can be the same for a number of devices in the project. It high‐
lights that these devices realize an application together, by responding to one another
for example.
7 C
ONFIGURATION
90
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/15ZT/2019-11-14 | SICK
Subject to change without notice