7.4 Addressing
Overview
Figure 58: Addressing
1
Values in the project
2
Values in the device
3
Buttons to read or transmit values
NOTE
If a de
vice has already been configured, the entire configuration will be transmitted
from the project to the device when the IP settings are changed. The configuration of
the control may also be invalid.
b
Before changing the IP settings: read the configuration from the safety laser scan‐
ner with Safety Designer and save if necessary.
Addressing
If communic
ation between the device and a control or a PC will be established via
TCP/IP, please enter the IP settings here.
b
Enter the IP address, subnet and, if necessary, router IP address.
7 C
ONFIGURATION
88
O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™ 8020200/15ZT/2019-11-14 | SICK
Subject to change without notice
To Next Page
Loading...
