SICK microScan3 EtherNet/IP - Data Recorder

11.4.1 Data recorder
Overview
Figure 89: Data recorder
Y
ou can use the data recorder to record the device’s signals continuously. The measure‐
ment data are not transmitted and shown for every scan cycle, depending on the inter‐
face and your capacity.
The data is saved in a data recorder diagnostics file.
The data recorder diagnostics file can be run in the data recorder.
Settings can be made in the safety designer frame.
Start recording
Stop recording
Typical applications
•
Check spatial geometry
•
Check where a person can stay or when a person is detected
•
Check input information about the current monitoring case
•
Check why safety outputs have switched
Prerequisites
•
Existing connection between Safety Designer and device
•
Configuration in the project and configuration in the device are synchronized
TROUBLESHOOTING 11
8020200/15ZT/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – EtherNet/IP™
151
Subject to change without notice