7.1.14 MF2 menu
You can parameterize MF2 in this menu and its submenus.
Requirement for display:
•
more? menu: Yes option
•
Menu MFx On: Enable option
Table 19: MF2 menu
Parameter Description
ActSta Select active MF2 level.
Options
•
ActLow: LOW level output with active output (safety criterion fulfilled)
•
ActHi: HIGH level output with active output (safety criterion fulfilled)
Factory setting
•
ActLow
Functn Select MF2 function.
Options
•
Dist: MF2 is used as a distance switch output.
•
Speed: MF2 is used as a speed switch output.
•
Srvice: MF2 is used as a service output.
Factory setting
•
Srvice
Count Counts the switching events of the MF2. You can reset the counter by
switching the device off and on again.
MF2 – Dist submenu
This submenu corresponds to the Dist submenu in the MF1 menu see "MF1 – Dist
submenu", page 38.
MF2 – Speed submenu
This submenu corresponds to the Speed submenu in the MF1 menu see "MF1 – Speed
submenu", page 39.
MF2 – Srvice submenu
This submenu corresponds to the Srvice submenu in the MF1 menu see "MF1 – Srvice
submenu", page 40.
7.1.15 Offset menu
You can set an offset in this menu.
Requirement for display:
•
more? menu: Yes option
OPERATION 7
8015069/19H9/2021-10-15 | SICK O P E R A T I N G I N S T R U C T I O N S | DL100 Pro PROFINET
43
Subject to change without notice
To Next Page
Loading...
