4 Mounting
4.1 Scope of delivery
•
SLG-2:
Light grid sender + light grid receiver (when ordered as a pair)
•
Quickstart
•
Safety notes
The mounting accessories and connecting cables are not included in the scope of
delivery and must be purchased separately.
4.2 Mounting requirements
•
Compliance with the minimum distance between sender and receiver in paral‐
lel-beam or cross-beam mode, see "Technical data", page 51.
•
Typical space required for device, see "Technical data", page 51.
•
Comply with technical data, such as the permitted ambient conditions for opera‐
tion of the device (e.g., temperature range, EMC interference emissions, ground
potential).
•
To prevent condensation, avoid exposing the device to rapid changes in tempera‐
ture.
•
For outdoor use only with appropriate safeguard / protective housing
•
Protect the device from direct sunlight.
•
Protect the device from external light sources.
•
Only fasten the device using the slot provided for this purpose and the mounting
bracket or sliding nuts available as accessories.
•
Shock and vibration-free mounting
4.3 Mounting conditions
Synchronization beam
For measuring tasks, it must be ensured that the first or last beam is always free, see
"Sync error", page 47.
Avoiding reflections
Reflective objects in the field of view may cause the image to be reflected or diverted
away. This means that reliable detection cannot be guaranteed.
Depending on the sensing range, make sure that there are no reflective objects in the
field of view of the light grid.
The minimum distance to reflective materials can be seen in the following graphic.
MOUNTING 4
8026014/2021-06-10 | SICK O P E R A T I N G I N S T R U C T I O N S | SLG-2
17
Subject to change without notice
To Next Page
Loading...
Need help?
General
