6 COMMISSIONING
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
Click OK to confirm. The device drivers are installed. The 2D LiDAR sensor will now be
detected by the configuration PC.
▸
In the device tile, click the pen icon next to the IP address.
▸
In the TCP/IP settings window, select the Use the following IP settings option and
define the IP address that is to be used to access the 2D LiDAR sensor in the sensor
network.
Click OK to confirm the entry. The altered IP address is displayed in the device tile.
NOTE! If the configuration PC and the 2D LiDAR sensor are still in the same number
range, the connection to the altered IP address of the 2D LiDAR sensor can be
established directly.
Changing the
IP address
To Next Page
Loading...