Siemens 1FP1/3 - O-Ring Seal

9.4.10 O-ring seal
If O-ring seals are present, you should check that they are in perfect condition and that the O-ring
seals are properly seated in the grooves between the components. Replace damaged O-ring
seals.
O-ring seals can be present on the following components, for instance:
• Adapters, tapers
• Entries, glands
• Bearing seals
• End shield seals
• Terminal box sealing
• etc.
Maintenance
9.4Corrective maintenance
1LE1, 1FP1/3, 1PC1/3 shaft height 63 ... 315
Operating Instructions, 11/2023, A5E38483075A 113