To energize the system, apply the measures in reverse order.
2.1.3 Qualied personnel
All work at the machine must be carried out by qualied personnel only. For the purpose of this
documentation, qualied personnel is taken to mean people who fulll the following
requirements:
• Through appropriate training and experience, they are able to recognize and avoid risks and
potential dangers in their particular eld of activity.
• They have been instructed to carry out work on the machine by the appropriate person
responsible.
2.1.4 Safe handling
Workplace safety depends on the attentiveness, care, and common sense of the personnel who
install, operate, and maintain the machine. In addition to the safety measures cited, as a matter
of principle, the use of caution is necessary when you are near the machine. Always pay
attention to your safety.
Also observe the following to prevent accidents:
• General safety regulations applicable in the country where the machine is deployed.
• Manufacturer-specic and application-specic regulations
• Special agreements made with the operator
• Separate safety instructions supplied with the machine
• Safety symbols and instructions on the machine and its packaging
Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum clearance and creepage distances may be
violated when coming close to live parts. Touching or coming close to them can result in death,
serious injury or material damage.
• Ensure that all live parts are suitably covered.
• Switch o and disconnect the machine rst if you want to remove covers. Observe the "5
safety rules".
Safety information
2.1General safety instructions
1LE1, 1FP1/3, 1PC1/3 shaft height 63 ... 315
16 Operating Instructions, 11/2023, A5E38483075A
To Next Page
Loading...
Need help?
General