Siemens 1FP1/3 - Operation; 8.1 Safety instructions for operation

Operation
8
Comply with the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page15).
• Comply with the applicable national and sector-speci󹪝c regulations.
• When using the motor within the European Union, comply with the speci󹪝cations laid down
in EN50110‑1 regarding safe operation of electrical equipment.
8.1 Safety instructions for operation
Hazardous voltages at the machine
Electrical machines have hazardous voltage levels. Contact with these can result in death,
serious injury or material damage.
Operating the machine on a line supply system with a non-grounded neutral point is only
permissible for short periods of time that occur rarely, e.g. the time leading to a fault being
eliminated. Cable ground fault EN/IEC 60034-1.
8.1.1 Safety instructions in operation - uncovered, rotating parts
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can cause sparking with subsequent ignition of
an explosive atmosphere resulting in death, serious injury or material damage.
• Carefully ensure that all of the covers are closed while operational.
• First switch o󹪜 and disconnect the machine if you must remove covers. Carefully comply with
the "5 safety rules (Page15)".
• Only remove the covers when the rotating parts have come to a complete standstill.
1LE1, 1FP1/3, 1PC1/3 shaft height 63 ... 315
Operating Instructions, 11/2023, A5E38483075A 85