If the paint is damaged, it must be repaired in order to protect the unit against corrosion.
Note
Paint system
Contact the ServiceCenter (Page12) before you repair any damage to paint. They will provide
you with more information about the correct paint system and methods of repairing paint
damage.
9.3 Inspection and maintenance
9.3.1 Safety instructions for inspection and maintenance
Danger as a result of stationary parts under voltage (live parts)
Live parts represent a hazard. Touch protection against active (live) parts is no longer
guaranteed if covers are removed. The minimum air and creepage distances may be fallen below
(violated) when coming close to active parts. Touching or coming close can result in death,
serious injury or material damage.
• Carefully ensure that all of the covers are closed while operational.
• First switch o and disconnect the machine if you must remove covers. Carefully comply with
the "5 safety rules" (Page15).
• In operation, the terminal box must always be kept closed. It is only permissible to open the
terminal box when the motor is stationary and in a no voltage condition.
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can cause sparking with subsequent ignition of
an explosive atmosphere resulting in death, serious injury or material damage.
• Carefully ensure that all of the covers are closed while operational.
• First switch o and disconnect the machine if you must remove covers. Carefully comply with
the "5 safety rules (Page15)".
• Only remove the covers when the rotating parts have come to a complete standstill.
Maintenance
9.3Inspection and maintenance
1LE1, 1FP1/3, 1PC1/3 shaft height 63 ... 315
96 Operating Instructions, 11/2023, A5E38483075A
To Next Page
Loading...
Need help?
General