Centrifuge Module Interface Operating Instructions Introduction
092D0001-02 Rev. A page 23
• OK to Pick When checked, indicates the sample tube is ok to pick.
• Picking When checked, indicates the sample tube is being picked.
• Place Request When checked, indicates a place request was made.
• OK to Place When checked, indicates system is permitted to place the
sample tube.
• Placing When checked, indicates the system is in the process of
placing the sample.
Gate Pick Position Area
The system uses the Gate Pick Position area checkboxes to display the
status of a tube or puck at the interface gate. They are not operator
selectable:
• Tube When checked, indicates a tube is at the interface gate pick
position.
• Puck When checked, indicates a puck is at the interface gate pick
position.
• Pick Barcode Displays the bar code number of the tube at the interface
gate pick position.
Gate Place Position Area
The system uses the Gate Place Position area checkboxes display the
status of the tube or puck at the interface gate place position. They are not
operator selectable:
• Tube When checked, indicates a tube is at the interface gate place
position.
• Puck When checked, indicates a puck is at the interface gate place
position.
• Place Barcode Displays the bar code number of the tube at the
interface gate place position.
Centrifuge Contents Area
Selecting an area checkbox and then selecting the Display button displays
information specific to the currently selected area:
• Sample Area
• Hettich
A list of the information is provided for each area:
• Number of sample tubes in the cassette
• Weight of the cassette
To Next Page
Loading...
