Startup
A31003-S2010-M100-18-76A9
2-10 OpenStage HFA Family, Administration Manual
inbetriebnahme.fm
Quick Start
• IP Address: IP Address for the phone.
• Subnet Mask (option #1): Subnet mask of the phone.
• Default Route (option #3 "Router"): IP Address of the default gateway which is used for
connections beyond the subnet.
• DNS IP Addresses (option #6 "Domain Server"): IP Addresses of the primary and sec-
ondary DNS servers.
If no DHCP server is present, see section 3.3.3, “IP Address - Manual Configuration” for IP ad-
dress and subnet mask, and section 3.3.4, “Default Route/Gateway” for default route.
2.3.3 Extended Network Configuration
To have constant access to other subnets, you can enter a total of two more network destina-
tions. For each further domain/subnet you wish to use, first the IP address for the destination,
and then that of the router must be given. The option’s name and code are as follows:
• option #33 "Static Routing Table"
For manual configuration of specific/static routing see section 3.3.5, “Specific IP Routing”.
Also the DNS domain wherein the phone is located can be specified by DHCP.
The option’s name and code are as follows:
• option #15 "Domain Name"
For manual configuration of the DNS domain name see section 3.3.6.1, “DNS Domain Name”.
2.3.4 VLAN Discovery
If the phone is to be located in a VLAN (Virtual LAN), a VLAN ID must be assigned. If the VLAN
shall be provided by DHCP, VLAN Discovery must be set to "DHCP" (see section 3.2.2.1, “Au-
tomatic VLAN discovery using DHCP”). The corresponding DHCP option is vendor-specific,
thus a specific procedure is necessary.
2.3.4.1 Using a Vendor Class
It is recommended to define a vendor class on the DHCP server, thus enabling server and
phone to exchange vendor-specific data exclusively. The data is disclosed from other clients.
The following steps are required for the configuration of the Windows DHCP server.
Setting up a new vendor class using the Windows DHCP Server
1. In the Windows Start menu, select Start > Programs > Administrative Tools > DHCP.
2. In the DHCP console menu, right-click the DHCP server in question and select Define
Vendor Classes... in the context menu.
To Next Page
Loading...
Need help?
General