EasyManuals Logo

Siemens HiPath 3000 Administration Manual

Siemens HiPath 3000
240 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
administration.fm
A31003-S2010-M100-18-76A9
OpenStage HFA Family, Administration Manual
3-29
Administration
System Settings
3.5 System Settings
3.5.1 System Identity
3.5.2 HFA Gateway Settings
To connect the OpenStage phone to the HiPath Communication System, the data described in
the following is required.
The Gateway address is the IP address of the communication platform resp. HFA server.
The Gateway port is the port used by the HFA server for signaling messages. Usually, the de-
fault value "4060" is correct.
The Subscriber number is used as the internal extension number of the phone. It can be 1 to
24 characters long.
To log on to the HFA server, a subscriber password must be provided. A New subscriber pass-
word can be entered by the administrator.
Data required:
Gateway address: IP address of the communication platform resp. HFA server.
Gateway port: The HFA server’s port for signaling.
Default: "4060".
Subscriber number: The phone’s extension.
New subscriber password: Password for logging on to the HFA server.
Optionally, a Gateway ID can be provided. The Gateway ID refers to the PBX/Gateway/Gate-
keeper to which the phone is connected. The value is the same as the "Globid" parameter in
the HiPath 4000 resp. the "H.323 ID" in the HiPath 3000.
The System type is provided by the system the phone is connected to and therefore read-only.
Administration via WBM
System > Gateway

Table of Contents

Other manuals for Siemens HiPath 3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens HiPath 3000 and is the answer not in the manual?

Siemens HiPath 3000 Specifications

General IconGeneral
BrandSiemens
ModelHiPath 3000
CategoryTelephone
LanguageEnglish

Related product manuals