Siemens HiPath 3000 - Page 70

Administration
A31003-S2010-M100-18-76A9
3-26 OpenStage HFA Family, Administration Manual
administration.fm
IP Network Parameters
• Trap destination / Manager address: IP address or hostname of the SNMP manager that
receives traps.
• Trap destination port / Manager port: Port on which the SNMP manager is receiving
TRAP messages.
Default: 162.
• Trap community / Community password: SNMP community string for the SNMP man-
ager receiving TRAP messages.
• Queries allowed: Allows or disallows queries by the SNMP manager.
Value range: "Yes", "No".
Default: "No".
• Query password: Password for the execution of a query by the SNMP manager.
• Diagnostic sending enabled: Enables or disables the sending of diagnostic data to the
SNMP manager.
Value range: "Yes", "No".
Default: "No".
• Diagnostic destination: IP address or hostname of the SNMP manager receiving diag-
nostic data.
• Diagnostic destination port: Port on which the SNMP manager is receiving diagnostic
data.
• Diagnostic community: SNMP community string for the SNMP manager receiving diag-
nostic data.
• QoS traps to QCU: Enables or disables the sending of TRAP messages to the QCU serv-
er.
Value range: "Yes", "No".
Default: "No".
• QCU address: IP address of the QCU server.
• QCU port: Port on which the QCU server is listening for messages.
Default: 12010.
• QCU community: QCU community string.
• QoS to generic destination / QoS to generic device: Enables or disables the sending of
QoS traps to a generic destination.
Value range: "Yes", "No".
Default: "No".