Siemens Hipath 5000 - Page 79

Alphabetical Reference
79
Key Test
• Test to check the functions of the telephone keys.
• If you press a function key, the associated LED lights.
• In display telephones, the corresponding name is shown on the  LCD
display when you press a key (exception : - terminates the test).
 Page 33
L2 Default
• This parameter describes the QoS values of each package, which is
neither a voice nor a signaling package.
• Default value  Page 109.
 Page 63
L2/L3 Voice/Signaling
• Can only be defined if  Layer 3 support is activated ( QoS L2/L3).
The value describes the position in the  Layer 2 value.
• Valid values: 0 ... 63.
• Default values  Page 109.
 Page 63
Lan Port 2 Auto MDIX Enabled
• You can activate/deactivate the second LAN port (PC port) Auto MDIX
here.
• Full support is only provided with  NetBoot Version 3.08.
 Page 26  Page 62
Lan Port 2 Enabled
• You can activate/deactivate the second LAN port (PC port) here.
• Full support is only provided with  NetBoot Version 3.08.
 Page 25  Page 62
LAN Port Settings
• You can define the bandwidth here at which the optiPoint 410/420 is to
be operated. The required value depends on the bandwidth that the
switch or router supports in the network.
• A restart is necessary after the change.
 Page 24  Page 62
Bandwidth Possible application
Auto In standard case
10/Full In 100 Mbit networks in full duplex
[1]
mode.
[1] Data can be sent and received simultaneously
10/Half In 10 Mbit networks with half duplex
[2]
mode.
[2] Data can only be sent or received at the same time
100/Full In 100 Mbit networks in full duplex
[1]
mode.
100/Half In 10 Mbit networks with half duplex
[2]
mode.