Alphabetical Reference
93
VLAN Method
• Can only be defined if  Layer 2 support is activated ( QoS L2/L3).
• You can specify here from where the  Default VLAN ID is to be
fetched when using  VLANs.
 Page 23  Page 18  Page 62
WAP Connection Type
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Choose the protocol to be used for transferring data for WAP
applications (
 HTTP or  WSP).
 Page 56
WAP Favourites
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Select your  WAP favourites from the list box. If no entries are
available, the list entry <empty> is displayed. For entering favourites,
see
 WAP Title.
 Page 57
WAP Password
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Enter a password for WAP gateway access.
 Page 56
WAP User Name
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
• Enter the user name for WAP gateway access.
 Page 56
WAP Gateway Address
• Only configurable on optiPoint 410/420 standard/advance and only
required if a display
module or application module is used.
•If a  WAP server is being used, enter the  IP Address of this server
here.
• Default address  Page 109.
 Page 56
Manual The ID entered under  Default VLAN ID is used.
DHCP When using a  DHCP server, the ID supplied by
this server is used.
To Next Page
Loading...
