Siemens Hipath 5000 - Communicating with PC Applications over a CSTA Interface

More functions/services
139
Step by Step
Communicating with PC applications
over a CSTA interface
If configured (contact your service personnel), you can
use your phone to communicate with PC applications
(CSTA = Computer Supported Telecommunications
Applications). You send information to the application
and receive information from the application,
for example, via your phone display.
S Press the "Data I/O" key, key programming Æ page 91.
j Enter the three-digit ID for the application you wish to
control.
e, 0...9 Use the TouchGuide and the keypad for communication
with the application.
Temporarily interrupting communication with the
application
^ The phone is ringing. You answer the call.
T The LED on the "Data I/O" key flashes: Communication
to the application is automatically interrupted.
Resuming communication with the application
T Press the flashing "Data I/O" key. The LED lights up.
Ending communication with the application
Select and confirm the relevant CSTA message.
or
^ \ Lift the handset and replace it again.