NOTICE
Risk of collision
Modified approach/retract angles must be taken into account during programming in order
that potential collisions can be avoided.
Approach/retraction with KONT
Prior to the approach, the tool can be located in front of or behind the contour. The path tangent
at the starting point serves as a separation line:
6WDUWLQJSRLQW
%HKLQGWKHFRQWRXU
,QIURQWRIWKHFRQWRXU
3DWKWDQJHQW
Fundamentals
2.10 Tool radius compensation
NC programming
264 Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
To Next Page
Loading...
Need help?
General
