Definitionen und Warnhinweise Issue 01/05
CANopen Option Module Operating Instructions
4 6SE6400-5BC00-0BP0
Additional information can be found in the Internet under:
http://www.siemens.de/micromaster
The certified Siemens Quality for Software And Training
corresponds to DIN ISO 9001, Reg. No. 2160-01
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created by patent grant or registration of a utility model or
design, are reserved.
© Siemens AG 2002, 2004. All rights reserved.
MICROMASTER
®
is a registered trademark of Siemens AG.
It is possible that other functions are available which are not
described in this documentation. However, this does not
mean that we are responsible in providing such functions with
a new control system or when servicing the equipment.
We have checked the contents of this document to ensure
that they coincide with the described hardware and software.
However, differences cannot be completely excluded, so that
we do not accept any guarantee for complete conformance.
However, the information in this document is regularly
checked and necessary corrections will be included in
subsequent editions. We are grateful for any
recommendations for improvement.
Siemens Manuals are printed on chlorine-free paper from
professionally managed forests. No solvents are used for
printing or binding.
Changes to this documentation can be made without prior
notice.
Order No.: 6SE6400-5BC00-0BP0
Printed in Germany
Siemens-Aktiengesellschaft.
To Next Page
Loading...
