EasyManuals Logo

Siemens MICROMASTER 430 User Manual

Siemens MICROMASTER 430
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Issue 01/05 Definitions and Warning Information
CANopen Option Module Operating Instructions
6SE6400-5BC00-0BP0
5
Definitions and Warning Information
Safety Guidelines
This documentation contains notes which you should observe to ensure your own
personal safety and also to prevent material damage. The information and
instructions for your personal safety are identified by a warning triangle. Information
and instructions on general material damage do not have a warning triangle.
depending on the degree of danger, they are indicated as follows:
DANGER
For the purpose of this documentation and on the warning label of the product
itself, "Danger" indicates that death, grievous injury or extensive damage to
property will occur if the appropriate precautions are not taken.
WARNING
For the purpose of this documentation and on the warning label of the product
itself, "Warning" indicates that death, grievous injury or extensive damage to
property may occur if the appropriate precautions are not taken.
CAUTION
"Caution" with a warning triangle, means that minor personal injury may occur if the
appropriate precautions are not taken.
CAUTION
"Caution" without a warning triangle, means that damage to property may occur if
the appropriate precautions are not taken.
NOTICE
means that an undesirable situation or condition can occur if the appropriate
information/instruction is not observed.
NOTE
For this purpose of this documentation, "Note” highlights an important item of
information about the product or a section of the instructions which requires careful
attention.

Table of Contents

Other manuals for Siemens MICROMASTER 430

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MICROMASTER 430 and is the answer not in the manual?

Siemens MICROMASTER 430 Specifications

General IconGeneral
Power Range7.5 kW to 250 kW
Voltage Range380V to 480V
Frequency Range0 Hz to 650 Hz
Protection ClassIP20
Input Frequency47 Hz to 63 Hz
Digital Inputs6
Cooling MethodForced-air cooling
CommunicationUSS
Protection FeaturesOvervoltage, undervoltage, overcurrent, short-circuit, ground fault, overtemperature
Analog Inputs2
Digital Outputs3
Analog Outputs2
Ambient Temperature-10°C to +50°C
Control TypeSensorless vector control

Related product manuals