Siemens MICROMASTER 440 Series User Manual

Index International English
MICROMASTER 440 Operating instructions
110 6SE6400-5CA00-0BP0
M
Main characteristics · 16
Mechanical Installation · 23
MICROMASTER 440
available options · 90
general · 16
main characteristics · 16
performance characteristics · 17
protection characteristics · 17
specifications · 77
Motor connections · 26
Motor data · 42
Multi-point V/f control · 49
O
Operation
starting and stopping the motor · 47
Operation with
long cables · 26
Residual Current Device · 25
ungrounded IT supplies · 25
Operator panels
Advanced Operator Panel · 43
Basic Operator Panel (BOP) · 39
changing the operator panel · 97
Status Display Panel (SDP) · 35
Overheating · 22
Overview · 15
P
Parameters
changing parameters with BOP · 41
system parameters · 51
Performance characteristics · 17
Performance Ratings · 78
Power and motor connections · 26
single phase · 28
Power and motor terminals
gaining access to · 26
Power connections · 26
Protection characteristics · 17
Q
Quadratic V/f control · 49
Qualified personnel · 6
Quick commissioning · 34, 37
R
Removal of Covers Frame Size D and E ·
101
Removal of Covers Frame Size F · 102
Removing ‘Y’ Cap Link Frame Size A · 103
Removing ‘Y’ Cap Link Frame Sizes B and
C · 104
Removing ‘Y’ Cap Link Frame Sizes D and
E · 105
Removing ‘Y’ Cap Link Frame Sizes F · 106
Removing Covers Frame Size A · 98
Removing Covers Frame Sizes B and C ·
100
Removing the I/O Board · 99
Reset to Factory default · 34
Residual Current Device
operation with · 25
S
Safety instructions · 7
Screening Methods · 29
Sensorless Vector Control · 49
Shock · 22
Specifications · 79
Status Display Panel
default settings with BOP · 39
operation with SDP · 35
warnings and faults states · 35
T
Technical Support · 5
Temperature · 22
Torque Control · 49
Troubleshooting · 67
U
Ungrounded (IT) supplies
operation with · 25
V
Variant Dependent Options · 90
Variant Independent Options · 90
Vibration · 22
W
Warnings, cautions & notes
commissioning · 8
definitions · 6
http://nicontrols.com

Siemens MICROMASTER 440 Series Specifications

General

Power Range	0.12 kW to 250 kW
Output Voltage	0V to Input Voltage
Frequency Range	0 Hz to 650 Hz
Overload Capacity	150% for 60 seconds, 200% for 3 seconds
Cooling Method	Forced air cooling
Enclosure Rating	IP20
Control Modes	Vector control
Protection Features	Overvoltage, undervoltage, short circuit
Communication Interfaces	PROFIBUS, CANopen, RS485
Operating Temperature	-10°C to +50°C
Input Voltage	200 V to 240 V (±10%), 380 V to 480 V (±10%)