Siemens MICROMASTER 440 Series - MICROMASTER 440 Operating Instructions 6 SE6400-5 CA00-0 BP0

International English Table of Contents
MICROMASTER 440 Operating instructions
6SE6400-5CA00-0BP0
13
List of Illustrations
Figure 2-1 Drill pattern for MICROMASTER 440....................................................................................22
Figure 2-2 MICROMASTER 440 Connection Terminals ........................................................................26
Figure 2-3 Motor and Power Connections..............................................................................................27
Figure 2-4 Wiring Guidelines to Minimize the Effects of EMI .................................................................29
Figure 3-1 Inverter block diagram ..........................................................................................................33
Figure 3-2 Panels available for the MICROMASTER 440 Inverter.........................................................34
Figure 3-3 Basic operation with SDP .....................................................................................................36
Figure 3-4 DIP locations on I/O board and the Control Board................................................................36
Figure 3-5 Buttons on the Basic Operator Panel....................................................................................38
Figure 3-6 Changing parameters via the BOP .......................................................................................39
Figure 3-7 Typical Motor Rating Plate Example.....................................................................................41
Figure 5-1 Quick Commissioning Flowchart...........................................................................................51
List of Tables
Table 2-1 Dimensions and Torques of MM440 (all frame sizes)...........................................................23
Table 3-1 Default settings for operation using the Status Display Panel...............................................35
Table 3-2 Default settings for operation using the BOP ........................................................................39
Table 6-1 Inverter conditions indicated by the LEDs on the SDP .........................................................68
Table 7-1 MICROMASTER 440 Performance Ratings .........................................................................78
Table 7-2 Wire Sizes & Terminal Torques – Field Wiring Connectors ..................................................79
Table 7-3 MICROMASTER 440 Specifications.....................................................................................79
Table 9-1 Class 1 - General Industrial ..................................................................................................94
Table 9-2 Class 2 - Filtered Industrial ...................................................................................................94
Table 9-3 Class 3 - Filtered for Residential, Commercial and Light Industry ........................................95
Table 9-4 Compliance Table.................................................................................................................96
http://nicontrols.com