Siemens MICROMASTER 440 Series - Figure 3-6 Changing Parameters Via the BOP

International English 3 Commissioning
MICROMASTER 440 Operating instructions
6SE6400-5CA00-0BP0
41
Changing parameters with the BOP
The following descriptions show how to change the parameters; use this
description as a guide for setting any parameters using the ‘BOP’.
Changing P0004 – parameter filter function
Step Result on display
1
Press
to access parameters
2
Press
until P0004 is displayed
3
Press
to access the parameter value level
4
Press
or
to the required value
5
Press
to confirm and store the value
6 Only the motor parameters are visible to the user.
Changing P1082 an indexed parameter – setting maximum motor frequency
Step Result on display
1
Press
to access parameters
2
Press
until P1082 is displayed
3
Press
to access the parameter value level
4
Press
to display current set value
5
Press
or
to the required value
6
Press
to confirm and store the value
7
Press
until r0000 is displayed
8
Press
to return the display to the standard
drive display (as defined by the customer)
Figure 3-6 Changing parameters via the BOP
http://nicontrols.com