5 System Parameters International English
MICROMASTER 440 Operating instructions
54 6SE6400-5CA00-0BP0
5.3 Parameter List (short form)
Three states are possible for all the parameters:
Commissioning C
Ready to run U
Run T
This indicates when the parameter can be changed. One, two or all three states
may be specified. If all three states are specified, this means that it is possible to
change this parameter setting in all three inverter states.
Always
Par. No. Parametername Default Acc WS QC
r0000 Drive display - 1 - -
P0003 User access level 1 1 CUT N
P0004 Parameter filter 0 1 CUT N
P0010 Commissioning parameter filter 0 1 CT N
Quick Commissioning
Par.-No. Parametername Default Level WS QC
P0100 Europe / North America 0 1 C Q
P3900 End of quick commissioning 0 1 C Q
Parameter Reset
Par.-No. Parametername Default Level WS QC
P0970 Factory reset 0 1 C N
Inverter Unit (P0004 = 2)
Par. No. Parametername Default Acc WS QC
r0018 Firmware version - 1 - -
r0026[1] CO: Act. DC-link voltage - 2 - -
r0037[2] CO: Inverter temperature [°C] - 3 - -
r0039 CO: Energy consumpt. meter [kWh] - 2 - -
P0040 Reset energy consumption meter 0 2 CT N
r0070 CO: Act. DC-link voltage - 3 - -
r0200 Act. power stack code number - 3 - -
P0201 Power stack code number 0 3 C N
r0203 Act. inverter type - 3 - -
r0204 Power stack features - 3 - -
P0205 Inverter application 0 3 C Q
r0206 Rated inverter power [kW] / [hp] - 2 - -
r0207 Rated inverter current - 2 - -
r0208 Rated inverter voltage - 2 - -
r0209 Maximum inverter current - 2 - -
P0210 Supply voltage 230 3 CT N
r0231[2] Max. cable length - 3 - -
P0290 Inverter overload reaction 2 3 CT N
P0292 Inverter overload warning 15 3 CUT N
http://nicontrols.com
To Next Page
Loading...
Need help?
General
