Siemens Micromaster Profibus - Fault Numbers for Cannot Process Request Response

(GLWLRQ$ &RPPXQLFDWLRQZLWK0,&520$67(5YLD352),%86'3
PROFIBUS Optional Board Operating instructions
6SE6400-5AK00-0BP0
27
Table 3-5 Fault numbers for "Cannot process request" response
1R 0HDQLQJ
0 Illegal parameter number (PNU) Parameter does not exist
1 Parameter value cannot be modified Parameter is a read-only parameter
2 Minimum/maximum not reached/exceeded -
3 Faulty subindex -
4 No array Single parameter has been accessed with
array request and subindex > 0
5 Incorrect data type Mix-up between word and double word
6 Setting not allowed (resetting only) -
7 Descriptive element cannot be modified Description can never be modified with
MICROMASTER4
11 No status as master control Modification request without status as master
control (see P0927)
12 Key word missing -
17
Request cannot be processed due to operating
state
Current converter status is not compatible with
the received request
101 Parameter number currently deactivated Dependent on converter status
102 Channel not wide enough
Communication channel too small for
response
104 Illegal parameter value Parameter permits only certain values
106 Request not implemented After request identifier 5, 10, 15
200/
201
Modified minimum/maximum not
reached/exceeded
Minimum/maximum can be further limited in
operation
204 Available access authorization does not cover
modification of parameters
-