EasyManua.ls Logo

Siemens MOBILETT Plus - Safety Information and Protective Measures

Siemens MOBILETT Plus
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Siemens AG SPR8-215.831.04.03.02 MOBILETT Plus/ -E/ -M
07.05 CS PS 24
General 13
Page 13 of 64
Medical Solutions
1.9 Safety information and protective measures
WARNING
Risk of death, injury or material damage.
Non-compliance can lead to death, injury or material damage.
¹ When performing service work and tests adhere to the
product-specific safety information in the documents.
¹ When performing service work and tests adhere to the
general safety information contained in ARTD Part 2.
¹ Only connect the MOBILETT Plus/Plus E/ Plus M to a
mains power supply outlet (receptacle) that corresponds
to the installation requirements of VDE 0107 or to coun-
try-specific regulations.
¹ Remove or install boards only when the generator is
switched OFF. Adhere to the ESD guidelines e .
¹ Checks and adjustments performed with radiation ON
are identified by the radiation warning symbol x . Dur-
ing these types of adjustments, radiation protective
clothing must be worn.
¹ Perform the protective conductor test according to
ARTD-002.731.17... upon completion of the work and
after all covers have been reattached.
WARNING
When working on the open unit there is a risk of electric shock!
Non-compliance can lead to injury or death.
Observe the following:
¹ Never work with the system open if the capacitor is
charging or has just been charged.
¹ The capacitor bank may still be charged even if the sys-
tem is switched OFF and the mains cable is discon-
nected. There is a risk of life-threatening electric shock.
¹ To avoid danger, refer to the section entitled “Protective
measures when working on the capacitor bank”.

Other manuals for Siemens MOBILETT Plus

Related product manuals