Revision Date: 3/13/2019
11
Squeeze Ball/Button Alarm
What to do when the Squeeze Ball/Button Alarm Goes Off
1. Stop the scanner using the mouse and clicking the stop icon in the lower left on the
console screen
2. To clear the alarm, press the talk button on the intercom associated with the squeeze ball
- Siemens (#2 talk or #3 alarm) or headphones button - Res Tech (TALK) you gave the
participant
3. Talk to your participant through the intercom system associated with the headphones you
gave your participant (res tech, siemens or opto system)
4. DO NOT press the “Stop” button (#1) on the Siemens Talk Box
5. If you press this, you will need to reset the table
6. To reset the table follow the below instructions
Reset the Table
1. Press the (#7) button on the side of the intercom box
2. Go into the scanner room and simultaneously press the Table Up and Table Down button
To Next Page
Loading...
