Revision Date: 3/13/2019
3
9. Wait a few seconds and then press the “system on” button on the Siemens scanner control
box located on the wall next to the MR Scanner window
10. When the scanner starts booting up, the LCD screen in the scanner room will turn back
on
11. It will take approximately 6 minutes for the system to completely boot up
How to Turn Off the MRI Scanner/Computer (Full Shutdown)
This type of full shutdown takes approximately 20 minutes – try this method if a “Standby”
reboot did clear the issue
1. Make sure the scanner bed is at the home position (all the way up and all the way out)
2. If a coil is on the table, all element should be plugged in
3. Click the “System” tab at the top of the screen
4. Click on “End Session”
5. Click “Shutdown System”
6. It will take approximately 5 minutes before you see “it is now safe to turn off your
computer”
To Next Page
Loading...
Need help?
General
