Revision Date: 3/13/2019
45
6. If the participant ID that appears on FIRMM's display is not correct for this session, you
will be asked to restart FIRMM after some DICOMs have been sent for your current
session
7. To restart, close FIRMM and relaunch the program - make sure you have collected at
least a localizer scan before you press start again.
8. To reload graphs from previous participants, click the Load Previous Scan button and
choose the participant
9. Close out all open windows on the dell desktop computer when you are done using
FIRMM and turn off the “ext” button on the switch box
To Next Page
Loading...
