Siemens Prisma 3T - Page 53

55 pages

To Next Page

To Previous Page

Revision Date: 3/13/2019

Equipment Manuals

Hard copies of manuals are located on the Prisma tech desk

Current Designs Button Box and Trigger Manual - Forp 932

ViewPoint Eyetracker User Guide*

ViewPoint Eyetracker Data Analysis Guide*

Optoacoustics Manual

MRI Safety Manual

*available online only – no hardcopy

Main Page

Table of Contents2
BMC Contacts5
Scanner Operation6
How to Do a "Standby" Reboot6
How to Turn off the MRI Scanner/Computer (Full Shutdown)7
How to Turn on the MRI Scanner/Computer8
MR Scanner Error Save Log8
How to Check the System Manager9
How to Restart the Coldhead10
How to Reboot the Chiller11
Export and Save Raw Data Files (.RDA and Raw)12
How to Map a Non-Dicom Network Folder on the Scanner Console12
How to Create a Spectroscopy .RDA File12
How to Transfer Raw Data Using TWIX Software13
Prisma Cleanup Procedures14
General Cleanup Guidelines14
Squeeze Ball/Button Alarm15
What to Do When the Squeeze Ball/Button Alarm Goes off15
Reset the Table15
How to Run the Daily Stability Warmup16
Setting up the Phantom16
Register Phantom16
Running Scans16
Registration Pictures17
How to Run the ABCD Phantom QA18
Setting up the Phantom18
Register the Phantom19
Running Scans20
Registration Pictures21
How to Trigger Test Stimuli/Tasks22
Setting up the Phantom22
Register Phantom22
Running Scans22
Registration Pictures23
Coil Warnings - Protocol was Fixed24
Main Reasons for Coil Warnings24
Anterior or Posterior Protocol Fixed Warning Messages24
Resolution24
Wrong Coil Protocol Fixed Warning Messages24
Prisma VE11C Software Bugs26
Autoalign Re-Run Failure26
AP/PA Copy Reference Issue26
Reconstruction Error (Aka Blob Error)27
Prisma VE11C Scanner Warnings/Messages/Errors28
Adjustment Measurement was Aborted28
Gradient Power Amplifier Warning28
Participant Registration Errors29
Slice Timing for BOLD Sequences and Other BOLD Questions30
Preparation Scans Related to Regular BOLD Sequences31
Current Designs Button Box and Trigger Setup (FORP 932)32
Device Selection32
Response Settings32
Troubleshooting33
Goggle Setup35
Tech Remote (Talk Box)35
Visuastim Controller35
Troubleshooting36
Resonance Technology Tech Remote (Talk Box) Setup37
Volume Settings37
Audio Input37
Comm. Mode Settings37
Tech Remote Reset38
Siemens Talk Box Setup39
Optoacoustics Headphone and Microphone Setup40
Positioning the Participant40
Setting up the Opto Console40
Using Active Noise Cancellation41
Troubleshooting Tips42
Boldscreen LCD43
Specifications43
Turning on the LCD43
Positioning the Participant43
Troubleshooting Tips44
How to Use E-Prime with the Desktop Computer and LCD45
Duplicate/Mirrored Display with E-Prime45
Extended Display with E-Prime45
Switching from Extended Display to Duplicate/Mirrored Display45
HCP Physiological Device Setup46
Ecg/Respiratory Setup46
Pulse Setup46
How to Use FIRMM to Monitor Motion During BOLD Scans47
Quick Overview47
Setup the Scanner Console47
Setup the Computer to View FIRMM47
Using FIRMM48
HCP Guidelines (See Full HCP SOP for more Details)50
After the Scan Is Complete50
How to Use the MR Camera51
Quick Overview51
Equipment51
Camera Setup51
Participant Setup52
Camera Cleanup52

Siemens Prisma 3T - Page 53

Table of Contents

Related product manuals