Siemens RUGGEDCOM RX1400 - Page 13

RUGGEDCOM RX1400
Installation Guide
Chapter 1
Introduction
Description 3
CELL LED Indicates when the cellular modem is connected to the network.
• Solid = Activity
• Off = No activity
Port Status LEDs Indicate the status of each port:
• Solid = Link
• Blinking = Activity
• Off = No link/activity
Access Plate The removable access plate provides access to the Micro SD card and SIM card slots.
• Use a Micro SD card to store the firmware and configuration for the device
• Use a single or dual (recommended) SIM cards to connect to an LTE network
RS232 Serial Console Port The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to Section2.11, “Connecting to the Device”.
ANT Ports SMA ports for connecting to an LTE network or Global Navigation Satellite System (GNSS).
For more information, refer to:
• Section2.6, “Connecting the Antennas”
• Section4.5, “Cellular Modem Specifications”
Failsafe Alarm Relay Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
• Section2.9, “Connecting the Failsafe Alarm Relay”
• Section4.2, “Failsafe Alarm Relay Specifications”
Power Supply Terminal Block A pluggable terminal block. For more information, refer to:
• Section2.10, “Connecting Power”
• Section4.1, “Power Supply Specifications”