Siemens RUGGEDCOM RX1400 Installation Guide

RUGGEDCOM RX1400
Installation Guide
Chapter 6
Certification
RoHS 49
Section6.1.14
RoHS
This device is declared by Siemens Canada Ltd to meet the requirements of the following RoHS (Restriction of
Hazardous Substances) directives for the restricted use of certain hazardous substances in electrical and electronic
equipment:
• China RoHS 2
Administrative Measure on the Control of Pollution Caused by Electronic Information Products
A copy of the Material Declaration is available online at https://support.industry.siemens.com/cs/ww/en/
view/109738831.
Section6.1.15
Other Approvals
This device meets the requirements of the following additional standards:
• IEEE 1613
IEEE Standard Environmental and Testing Requirements for Communications Networking Devices in Electric
Power Substations
• IEC 61850-3
General Requirements
• IEC 61000-6-2
Electromagnetic Compatibility (EMC) – Part 6-2: Generic Standards – Immunity for Industrial Environments
• NEMA TS-2
Traffic Controller Assemblies with NTCIP Requirements
Section6.2
EMC and Environmental Type Tests
The RUGGEDCOM RX1400 has passed the following Electromagnetic Compatibility (EMC) and environmental tests.
EMC Type Tests per IEC 61850-3
Test Description Test Levels
Severity
Levels
Enclosure Contact ± 8 kVIEC 61000-4-2 ESD
Enclosure Air ± 15 kV
4
IEC 61000-4-3 Radiated RFI Enclosure Ports 20 V/m
Signal Ports ± 4 kV @ 2.5 kHz, 5 kHz
Note
a
DC Power Ports ± 4 kV @ 2.5 kHz, 5 kHz
AC Power Ports ± 4 kV
IEC 61000-4-4 Burst (Fast Transient)
Earth Ground Ports ± 4 kV @ 2.5 kHz, 5 kHz
4
IEC 61000-4-5 Surge Immunity Signal Ports ± 4 kV Line-to-Earth

Siemens RUGGEDCOM RX1400 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1400
Category	Network Hardware
Language	English